CFHydroponics 9-Site Cloner Instructions
Includes:
  • 1 3 Gallon Bucket
  • 1 12” Clear Saucer
  • 1 160 GPM Pump
  • 9 2” Net Pots
  • 9 Neoprene Collars
  • 4 270° Mister Heads
Setup Instructions:
  1. Place the bucket in the saucer to catch any excess water that might trickle out.
  2. Fill bucket with 2 gallons of pH balanced water (Water should have a pH of 6-6.5)
  3. Place the lid on the bucket. The lid should snap into place.
  4. Plug in 160 GPM pump, the pump should be submerged in the water. The water should spray out of the mister heads and all the heads should be running. The mister heads should be above the surface of the water; do not submerge them.
  5. To clone your plant: cut the plant at the joint, where the pieces connect. Cut at a diagonal. The plant from which the clippings are coming should already be established.
  6. Place the clipping in the neoprene collar with the end sticking out the bottom. Place the collar with the clipping back in the net cup and into the bucket’s lid.
  7. Run the system 24-hours, 7 days a week until the roots push through. The cloner should be running at all times.
  8. Occasionally clean out the filter on the pump and nozzles of the mister heads.

Leave a comment